Thingiverse
Drone RC Antenna Spread
by 3DMaka
5
Downloads
3
Likes
0
Makes
Quick print for your drone RC / 8min / about a gram / I used petg any filament should work
The Turnigy / Flysky) Manual recommends to mount the antennas pointing 90 degrees from one another so that one of them is always receiving a signal at any given time.
The Turnigy / Flysky) Manual recommends to mount the antennas pointing 90 degrees from one another so that one of them is always receiving a signal at any given time.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!