Drone - Shendrones Corgi XT60 Backmount FLEX

This is a XT60 mount for the Shendrones Corgi.

##### Good to know:
* It is designed to be printed in flexible material!
* The plug may already be soldered!
* It needs to be printed in flexible material to fit inside otherwise it won't because the mold is smaller then the plug.
* You can use the top side as an anti-slip mat


##### How to print flexible material:

* There is a Bambu Guide on how to print TPU, i recommend reading this:
https://wiki.bambulab.com/en/knowledge-sharing/tpu-printing-guide
* DO NOT USE AN AMS TO PRINT TPU if its not TPU with a hardness of 77D or 55D!
* You can print on a Cool plate, PLA plate, engineering plate, high-temperature plate or textured PEI plate, just make sure the temperature is low (30°-35°).
* Use a 0.4 Nozzle.


##### How to mount it to the Frame:

1. Just pull your XT60 inside the flex mount from behind.
2. There is a 1mm edge on the frontside of the mount to hold the plug in position while connecting or disconnecti