Drone

Printed Motor MOUNTs and ARMs, going to install glass and heat bed before printing the body.

COMMENT, IDEAS, THOUGHTS are Greatly appreciated

V2.9 UPDATES
the ARMs printed good but I worry that the slant bridge design all in the same direction allows for to much flex. When my BangGood parts arrive i'll fly with the // support design until they break before switching to the X support. The motor MOUNTS printed strong and sturdy although the support material through Slic3r was quite difficult, (actually broke the first set when removing supports.

V2.7 UPDATES
The side walls were too small to later incorporate an FPV camera, also tell me your thoughts on the "Battery Cage". I fear it will add more weight then is really needed. I may just app slotted holes in the bed to later add velcro straps.

375mm tip to tip

M3x~~ bolts for electronics
M4x16mm Bolts

working on an effective universal bracket to mount the battery