Drone Workbench

Drone Workbench.

Mount your drone to the bench to easily remove props, do maintenance or just as a display piece.

I used the Diatone M540 to create this model but should work with most 5 inch drones.

To assemble:

I used threaded inserts and a small blowtorch to insert them into the drone mounting block.
The legs then just screw in with M3 screws and washers. I ended up using two part epoxy between the block and legs before fastening the screws and I am not planning on taking it apart again(This added a lot of rigidity to the assembly).

Link to the threaded insert:

https://www.banggood.com/100Pcs-M3-x-6mm-Brass-Knurled-Nuts-Insert-Female-Thread-Round-Insert-Embedded-Nuts-p-1184384.html?rmmds=myorder&ID=41528&cur_warehouse=CN