Drum stick back scratcher

A simple two-piece design to slide over the butt of the drum stick, for those hard to reach itchy spots :-)
This was designed around a 5A drum stick size.

I printed this with black Hatchbox TPU (the adapter) and black Hatchbox PLA (the scratcher) on an Ender 3 S1 Pro...
Both TPU and PLA were sliced using Creality Slicer v 4.8.2. And printed at low res with 10% infill.
PLA = 205 degrees C for nozzle and 65 degrees C for bed (no adhesion), TPU = 225 degrees C and 75 degrees for bed (with
raft adhesion)