MakerWorld
3D Printer Accessories
Ver Modelo
Dry Box Lid
44
Descargas
15
Likes
32
Makes
I modeled this from scratch taking inspiration from LTNine's dry box lid remix. I wanted to have lids for my dryboxes that did not have the hinge and had a positive retention lip to keep the lid firmly seated while still being able to feed filament through a bowden tube + PC4-M10 connector. The print profile includes a plate with TPU washers, though you could use rubber washers from the store instead. To assemble: Print out the parts. Leave the print profile support settings enabled, they are needed to print out the bottom of the cap threads. After the print is complete you can remove the supports with a pair of needle nose pliers. Obtain non-printable parts:PFTE tube (4mm OD, roughly 100-150mm of length)PC4-M10 Male Straight Pneumatic PTFE Tube Push in Quick Fitting ConnectorCereal box (all of mine are 4L Skroam Cereal Containers, but I think many of the brands are the same dimensions) Insert the PC4 connector into the hex shaped hole in the top of the lid. Screw the threaded nut
daevee también publica en
2 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!