Dry Box Remix

Starting with this fantastic thing (http://www.thingiverse.com/thing:961881) I made a few modifications
-Found a box in Costco just large enough to hold two rows of spools, 3-4 spools each, total of 6-8. It also fits perfectly in the Lack enclosure I'm building.
-Mounted flat disks (failed print, Attached "Disk" STL should work) outside with the rod holders (1/4" by the way, didn't see it listed on the original page) on the inside. This should relieve stress on the box's plastic sides
-Mounted filament guides inside and outside, drilling the center hole larger to ensure no impediment or scraping. If the inside guides are too close to the spools, I'll remove them.
-Created the attached "Filament Parking" STL in Tinkercad using the filament guide; the holes are blocked, so it's a decent spot to stick the end of the filament when not in use
-I printed several sets of this spool holder (http://www.thingiverse.com/thing:767317)

Note: Photo shows 0.5 Kg AIO Robotics spools.

Enj