Dryer Box Passthrough Plug for Printing

Problem: Recently I started printing from a dryer box (Creality Space Pi) to keep petg rapid filament dry while printing for longer hours on my A1 mini. The PTFE tube which comes with the printer would slide into the box while printing since the rubber ventilation plug that comes with this dryer box does not offer a tight fit for it to keep it in place. If the printing would be unattended, the dryer would risk falling on its side as the printer pulls the filament. It will cause an error once the PTFE tube is deep inside the dryer and it becomes either too short or pulls the dryer box down. Solution: ***[UPDATE - 2025-07-15] I have added another print profile that should allow using it with PETG (Rapid, HF, etc) while it's being dried at the same time. The original profile had issues where PETG filament would get stuck in the plug due to expanding when being dried. The original profile should be fine for PLA.*** A very quick print of this plug would allow inserting it into the dryer