Thingiverse
Drying rack foot
von alexmrqt
1
Downloads
1
Likes
0
Makes
This is a replacement for the broken foot for my drying rack.
I hope it can be usefull, in particular If you have the same model as me (see picture).
As this piece will be put under stress, you should print it with a very high infill (like 80-100%). But you may want to do some fit-testing with weaker pieces.
I suggest that you slice the model vertically, to prevent unreachable supports inside the piece.
Finally, it is not so easy to install the piece. I had to use a hammer for it to fit properly.
I hope it can be usefull, in particular If you have the same model as me (see picture).
As this piece will be put under stress, you should print it with a very high infill (like 80-100%). But you may want to do some fit-testing with weaker pieces.
I suggest that you slice the model vertically, to prevent unreachable supports inside the piece.
Finally, it is not so easy to install the piece. I had to use a hammer for it to fit properly.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
