Thingiverse
DSI NC2400 Chad Bin
von TubeTime
0
Downloads
0
Likes
0
Makes
This is a replacement chad bin for a DSI NC2400 paper tape punch.
Print at low quality resolution, otherwise it'll take a week. You will need to print with supports due to the guide channel underneath. On my Ender 3, this print took a little over 15 hours. I use a pair of side cutters to remove the support structure.
After printing, you will need to fabricate a small piece of steel, about 8x24mm. Glue this on the back of the chad bin, lined up with the magnetic catch on the inside of the NC2400 unit.
Print at low quality resolution, otherwise it'll take a week. You will need to print with supports due to the guide channel underneath. On my Ender 3, this print took a little over 15 hours. I use a pair of side cutters to remove the support structure.
After printing, you will need to fabricate a small piece of steel, about 8x24mm. Glue this on the back of the chad bin, lined up with the magnetic catch on the inside of the NC2400 unit.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!