Slicer Discord
DSS Hootsforce – 3D-Druckmodell von Thingiverse Thingiverse

DSS Hootsforce

30 Downloads
24 Likes
0 Makes
Zum Modell
Knocked this up on a whim using the Gloryhammer music video Hootsforce for reference. Test printed with a 0.4mm nozzle at 0.1mm layer height. I'd advise replacing the printed antenna/periscope with a short bit of wire if you care about it at all.
Quelle
Thingiverse
Was du zum Drucken brauchst: Mittel Mittlere Konfidenz
Warum?
Supports nötig · 0.10mm Schichten
Einteilig Supports nötig
Supports 2/3
Zusammenbau 0/3
Einstellungen 2/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Schichthöhe
0.1 mm
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen