Cults3D
Gadget
Model downloaden
DT3 USB Cable Tester Case
2
Downloads
0
Likes
0
Makes
DT3 USB Cable Tester Case
by RebelTaz
This is a case for the DT3 USB cable tester board. Due to the design of the board, the board will have to be held into the case with double sided tape.
The entire reason for this case was because the indicator LEDs are WAY over powered and WAY too bright. I placed a drop of clean resin in each LED hole at the top, curing each one with a UV light before going to the next. You could also use hot glue, which was my original plan.
I have also included a decal.svg sheet if you would like to label it as I did. I printed it with a laser printer on clear decal paper.
by RebelTaz
This is a case for the DT3 USB cable tester board. Due to the design of the board, the board will have to be held into the case with double sided tape.
The entire reason for this case was because the indicator LEDs are WAY over powered and WAY too bright. I placed a drop of clean resin in each LED hole at the top, curing each one with a UV light before going to the next. You could also use hot glue, which was my original plan.
I have also included a decal.svg sheet if you would like to label it as I did. I printed it with a laser printer on clear decal paper.
rebeltaz publiceert ook op
497 extra modellen op 3 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
