![DTAP Micro Voltmeter [0.28" display] – 3D-printbaar model van Thingiverse](/imgproxy.php?url=https%3A%2F%2Fcdn.thingiverse.com%2Fassets%2F35%2F23%2F5a%2Fda%2F7c%2Flarge_display_output-onlinejpgtools.jpeg&w=800&h=800)
Thingiverse
DTAP Micro Voltmeter [0.28" display]
door Jona623e
29
Downloads
25
Likes
0
Makes
A smart voltmeter housing that lets you monitor your camera or monitor's voltage at a glance.
Printed in nylon and tested in PLA (PETG would probably also be good). All you need is a 0.28" micro voltmeter, a bit of wire and a connector of your choosing (I use DTAP). The cable used is Van Damme 2 strand installation wire.
The through hole lets you mount the device anywhere in any orientation with a 1/4 20" screw
Assembly: solder wires onto voltmeter. Make sure they fit inside the shell. The wire and two shells are held in place with CA glue and clamped.
Printed in nylon and tested in PLA (PETG would probably also be good). All you need is a 0.28" micro voltmeter, a bit of wire and a connector of your choosing (I use DTAP). The cable used is Van Damme 2 strand installation wire.
The through hole lets you mount the device anywhere in any orientation with a 1/4 20" screw
Assembly: solder wires onto voltmeter. Make sure they fit inside the shell. The wire and two shells are held in place with CA glue and clamped.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
