Dual Angle Phone Stand

Hi, I was inspired by the Dual Angle Phone and Tablet Stand by Habs13, but made this from scratch in Fusion 360 to fit larger modern phones (5.5" and larger).

The two angles are 70 and 45 degrees.

The stand is 70 mm wide, and the height of the portrait side is 70 mm to accommodate larger phones. This stand accepts a phone depth of up to 15 mm, which fits a large smartphone in a case. The lip is 4.5 mm high to provide stability while not blocking the actual phone display or access to soft buttons, especially on curved screens.

Due to the increased size, the footprint of the stand is about 135 mm by 70 mm, which might be a consideration if you have limited desktop space.

Cutouts are angled at 50 degrees to allow easy printing, and the stand should be printed on its side with no supports needed.