Thingiverse
Dual Angle Phone Stand
von Nid3d
5
Downloads
2
Likes
0
Makes
The design offers two useful angles of support, easily swappable.
There are four flat recesses on the bottom for 6mm silicon feet.
A straight forward print. Slice standing on one side so no supports will be needed. Use a good brim base or even a raft. I used PLA+.
There are four flat recesses on the bottom for 6mm silicon feet.
A straight forward print. Slice standing on one side so no supports will be needed. Use a good brim base or even a raft. I used PLA+.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
