Thingiverse
Dual Cable Clip
por oglind_5399
0
Descargas
0
Likes
0
Makes
An easy to print cable holder/management design. Holds cables up to 5mm diameter.
can be used in a few ways, either with an M3x5.7mm threaded insert and a double sided adhesive on the back to stick it down.
Or because the base of the insert hole is thin, you could use it as a normal cable clip and put a screw straight through to secure it.
Great for things like networking cables or USB cables and can be used pretty much anywhere
No supports/rafts/brim required
can be used in a few ways, either with an M3x5.7mm threaded insert and a double sided adhesive on the back to stick it down.
Or because the base of the insert hole is thin, you could use it as a normal cable clip and put a screw straight through to secure it.
Great for things like networking cables or USB cables and can be used pretty much anywhere
No supports/rafts/brim required
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!