Thingiverse
Dual Garbage Can
door smark66
23
Downloads
18
Likes
0
Makes
Needed to save room by not having two separate recycle bins in the kitchen. Decided to split a 5 Gallon Home Depot pail into 2 sides for dual bags.
Print Thing file twice, one for each side of pail.
Tools required:
Has 2 x 4 mm diameter holes. Needs 2 coat hangers cut to length (min 14 cm) or rods or long screws. I used 2 pieces of coat hanger cut to length and used a bit of duct tape to wedge them into the holes.
Optional piece of cardboard to divide the pail. There are slots on the bottom of the print to support a piece of cardboard cut to size.
Print Thing file twice, one for each side of pail.
Tools required:
Has 2 x 4 mm diameter holes. Needs 2 coat hangers cut to length (min 14 cm) or rods or long screws. I used 2 pieces of coat hanger cut to length and used a bit of duct tape to wedge them into the holes.
Optional piece of cardboard to divide the pail. There are slots on the bottom of the print to support a piece of cardboard cut to size.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!