Thingiverse
Hobby
Zum Modell
Dual Headphone Stand
480
Downloads
401
Likes
6
Makes
A simple and easy to print headphone stand which holds two headphones!
Optimized for 200mm^3 build volumes.
Instructions:
1. Print each part. Supports are optional. I printed mine without supports.
2. Glue rod.STL to hanger.stl. Make sure the orientation of the height adjustment holes on the rod are correct!
3. Cut a 1.75mm piece of filament to length. This is used to adjust the height of the stand.
Done! The gold stand in my picture has some pipe insulation glued to the top and bottom for a more premium feel. The black stand in my picture was an earlier revision.
Post your makes! Leave credit where credit is due, and respect the non-commercial license!
Optimized for 200mm^3 build volumes.
Instructions:
1. Print each part. Supports are optional. I printed mine without supports.
2. Glue rod.STL to hanger.stl. Make sure the orientation of the height adjustment holes on the rod are correct!
3. Cut a 1.75mm piece of filament to length. This is used to adjust the height of the stand.
Done! The gold stand in my picture has some pipe insulation glued to the top and bottom for a more premium feel. The black stand in my picture was an earlier revision.
Post your makes! Leave credit where credit is due, and respect the non-commercial license!
SomePrintrNoob veröffentlicht auch auf
7 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
