Electronics
Zum Modell
Dual ISDT Charge Case
66
Downloads
44
Likes
1
Makes
Charge Case designed for two ISDT Q6 Chargers.
DWG files are the outlines of the substrate. The substrate used was hardboard with whiteboard on one side purchased at the local hardware store about 4.6mm thick. The prints themselves were Sainsmart TPU.
There is a somewhat detailed build thread on RC Groups at the following link:
https://www.rcgroups.com/forums/showthread.php?3080760-Dual-ISDT-Q6-Field-Charging-Case
I will post the details on the components used in the build thread. You can also ask questions here or there.
- Birger
DWG files are the outlines of the substrate. The substrate used was hardboard with whiteboard on one side purchased at the local hardware store about 4.6mm thick. The prints themselves were Sainsmart TPU.
There is a somewhat detailed build thread on RC Groups at the following link:
https://www.rcgroups.com/forums/showthread.php?3080760-Dual-ISDT-Q6-Field-Charging-Case
I will post the details on the components used in the build thread. You can also ask questions here or there.
- Birger
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!