Dual Saber Oculus Touch

Completely redrew the end cap and turned it in to a long handle to be more comfortable.

I didn't like the bottom of the controller mounts so I cut them off to make it easier to print. I also changed the cord holder to not need supports and hold the controller in tight without needing to tie it. You should be able to use the original controller mounts with this handle if you like.

Make sure to clean up the handle to remove any printing artifacts like sharp edges and/or blobs before using. I got several tiny cuts during my first test before cleaning it up.

Print both handle and hilts with at least 1.2mm thick walls and 30% infill. Either use exceptionally strong material or heat treat the print. I made mine in PETG with 2mm walls and was a bit too enthusiastic with my initial testing before I heated treated it and snapped at the handle. Afterwards I used a heat gun to fuse the handles outer layers together and it's going strong now. Print the 2 screws in 100% infill with a thic