Thingiverse
Dual XBOX Controller stand - extended
von calucita
8
Downloads
5
Likes
1
Makes
Model strongly based on https://www.thingiverse.com/thing:1196614
Only slight changes:
* Extra space/length such that any controller can be retrieved and put back without moving the other
* Slightly sleeper angle (very slightly)
* The bottom of the stand no longer ends in a single point.
Printed with 90% infill for extra weight and strength.
Can be printed with 0% infill, but it's a bit bouncy and light.
Only slight changes:
* Extra space/length such that any controller can be retrieved and put back without moving the other
* Slightly sleeper angle (very slightly)
* The bottom of the stand no longer ends in a single point.
Printed with 90% infill for extra weight and strength.
Can be printed with 0% infill, but it's a bit bouncy and light.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
