Thingiverse
DualSlim setup parts
by Wierzbowsky
0
Downloads
2
Likes
0
Makes
This is the set of parts to create a DualSlim solution - two slim floppy drives or one slim Gotek and one slim floppy drive merged together to be fit into a single FDD bay. To be able to use these 2 drives, you need the special DualSlim adapter that is available here:
https://github.com/RBSC/DualSlimAdapter
The default mode allows to install slim Gotek on top of FDD. Gotek is a bit shorter, so the holder takes it into account. The "DualFDD" version of the holder allows to install 2 FDDs of the same length.
The "noholes" variant of the model is for printing the holder horizontally, the holes on the first layer are covered with 0.2mm thick polygons. This helps to properly print the part when adhesion is not good.
If you want to make a small donation in appreciation of my humble efforts, please use the "Tip designer" button on this page:
https://www.thingiverse.com/Wierzbowsky/designs
https://github.com/RBSC/DualSlimAdapter
The default mode allows to install slim Gotek on top of FDD. Gotek is a bit shorter, so the holder takes it into account. The "DualFDD" version of the holder allows to install 2 FDDs of the same length.
The "noholes" variant of the model is for printing the holder horizontally, the holes on the first layer are covered with 0.2mm thick polygons. This helps to properly print the part when adhesion is not good.
If you want to make a small donation in appreciation of my humble efforts, please use the "Tip designer" button on this page:
https://www.thingiverse.com/Wierzbowsky/designs
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!