Thingiverse
Dub to BB86 bottom bracket adapter
by nachette93
2
Downloads
4
Likes
0
Makes
Adapter to go from Dub bearings to BB86/BB92 spindle (shimano cranks)
This is only a proof of concept, and created as a temporary measure until a proper BB86 bottom bracket arribes.
There are 2 options, either you can use the 2 small sleeves at each end of the crank or the single piece sleeve, which allows running with a smaller Q-factor
Ride at your own risk
(a fusion 360 file is attached to modify the measurements to suit your particular printer)
Printed at 0.2mm layer height and 0.4mm extrusion width
This is only a proof of concept, and created as a temporary measure until a proper BB86 bottom bracket arribes.
There are 2 options, either you can use the 2 small sleeves at each end of the crank or the single piece sleeve, which allows running with a smaller Q-factor
Ride at your own risk
(a fusion 360 file is attached to modify the measurements to suit your particular printer)
Printed at 0.2mm layer height and 0.4mm extrusion width
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
