Duck Wirly Wind

used Cura
4mm nozzle
.3mm layer height
wall line count 3
top layers 3
bottom layers 2
25% infill
print speed 55mm/s
infill speed 55mm/s
travel speed 150mm/s
support overhang angle 60

The time estimated by Cura match exactly the time it took for my CR10s to print. 1.5 hours for wing, nut and spacer. 2.5 hours for goose.


printed wing, spacer and nut at once
use a piece of close hanger, leave enough spacing (1 mm or greater) between the nut and the wing. Starting from outside in, nut, wing, spacer, goose, spacer, wing, nut. I used super glue to hold the nut on.

Print standing up on its tail feathers.
Fits on a 5mm dowel