Thingiverse
Ducky-Low-Poly
von MartyMacFly
14
Downloads
7
Likes
0
Makes
Hy Makers !
Here comes a low-poly-remix of the famous "Ducky The Lop Eared Bunny" ! (thanks to Yeg3d)
I used Blender to low-poly, and Meshmixer to check it.
Printed on my Ultimaker Exxxtended, about 5 hours, PLA, no rafts, but supports.
X : 9 cm / Y : 10 cm / Z : 9 cm
Enjoy, and tell me if this low-poly Ducky is "so cuuuuute" too ? :)))
Marty
Here comes a low-poly-remix of the famous "Ducky The Lop Eared Bunny" ! (thanks to Yeg3d)
I used Blender to low-poly, and Meshmixer to check it.
Printed on my Ultimaker Exxxtended, about 5 hours, PLA, no rafts, but supports.
X : 9 cm / Y : 10 cm / Z : 9 cm
Enjoy, and tell me if this low-poly Ducky is "so cuuuuute" too ? :)))
Marty
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!