Slicer Discord
Duct Crawler – 3D-Druckmodell von Thingiverse Thingiverse

Duct Crawler

97 Downloads
89 Likes
0 Makes
Zum Modell
Ok. Here is something no one else will ever make, but for edification I must publish it. To make the story short, my daughter’s bedroom did not have proper cooling/heat supply through the ducts. There is no crawlspace under the house, but all the supply ducts located under the floor. AC contractors told me they’ll have to tear up all the floors in her room plus 2 more rooms to figure out the problem. I’ve designed this crawler to get it into the 7” supply pipe, and provide a live feed via a HD Microsoft webcam, so I can inspect the ducts and figure out where the bottleneck is.
The tracks and motor/gearbox are from a Tamiya 70100 track and wheel set. The camera is a Microsoft HD webcam. The lights are from a $1 harbor freight over the counter pocket light
http://www.harborfreight.com/media/catalog/product/cache/1/image/9df78eab33525d08d6e5fb8d27136e95/i/m/image_14142.jpg.
I used only the reflectors and PCB, and replaced two LED’s with high intensity ones. The crawler can move forw
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA, Polycarbonate
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen