Duet 3 Universal Enclosure

Update 2:

The front wall has been tweaked to improve the hole sizes and locations of the USB port and audio jack. Also added a clean back wall for those who install a smaller power supply. I also included a block-off plate for those who already printed the original back wall, but want the large hole plugged and don't want to print or install a new back wall. At some point, my Duet 3 board 5v voltage regulator started producing low voltage, so instead of sending the board in, I purchased a Homelylife brand 5V 100W buck converter to power my raspberry Pi, which further powers my Duet 3 5v rail. I added an adapter bracket to install the buck convertor into the spare slot I put on the "board mounts" plate. Finally, I added an adapter to use the stock CR-10 spool holder. All newly-added parts should just require standard PC fan screws to mount.

Update:

The original Front Wall stl did not have a cutout to accomodate a small motherboard-mounted component below the right upper mount s