Thingiverse

Duet Wifi Case

par YogiG

311 Téléchargements

154 Likes

3 Makes

A case designed around the Duet Wifi, design choices were to focus on airflow while remaining svelte.

- Two 50mmx10 fans directing air over and above board. Channels to direct air under stepper drivers.
- Built in zip tie points along wall for cable management and two more in front to secure power and bed wires.
- Full rear panel access without having to remove anything.
- Reference notes recessed on inside wall for wire layout.
- Screws are threaded for M4-7 (10mm long is what I'm using)

- Two versions uploaded at the moment, one with feet and one without. I recommend supports for the bridge between the board and fans.

Thanks to the HEVO facebook group for being a great sounding board in laying this box out, much appreciated!

board case controller Duet Duet3D DuetWifi duet case Duet WiFi stepper wiring board case controller Duet Duet3D DuetWifi duet case Duet WiFi stepper wiring

Source

Thingiverse

Ce qu'il faut pour imprimer: Intermédiaire Confiance faible

Monobloc Visserie requise

Supports 1/3

Assemblage 0/3

Réglages 1/3

Taille du plateau 0/3

Post-traitement 1/3

Imprimante

FDM / FFF

Format de fichier