Thingiverse
Duet3D Ethernet Case
by dlsmith57918
9
Downloads
6
Likes
0
Makes
I decided to use a Duet3D Ethernet boar and Duet3D display on my Hypercube build. There were a few cases out there for Duet boards, but none of them were small enough to build with my QiDi Tech 1, so I designed this one.I JUST fits, and I had to remove the priming strip after it was laid down, or it would be in the printing area.
There are two cases, one with pads to mount a modfet bed heater controller and one without. There are also two lids, one with a logo and one without. The lid is attached with #6 X 3/8" sheet metal screws.
The case has mounting holes and cutouts to mount an 80 fan to cool the board, although it runs ver cool as it is. In fact I need to put a PWM controller in the fan circuit to slow it down, as it is the loudest thing on the printer.
There are two cases, one with pads to mount a modfet bed heater controller and one without. There are also two lids, one with a logo and one without. The lid is attached with #6 X 3/8" sheet metal screws.
The case has mounting holes and cutouts to mount an 80 fan to cool the board, although it runs ver cool as it is. In fact I need to put a PWM controller in the fan circuit to slow it down, as it is the loudest thing on the printer.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
