Dumb remote automation

My new motorized blind comes with a simple, RF dumb remote. You have to manually push buttons to close or open.

The blind is very useful to prevent the heat to spread inside the house in summertime. I looked for a solution to automatically close it when the temperature rises. And I came up with that low-tech, yet very satisfying solution : a device that physically pushes the buttons when it is needed.

I do not expect anybody to be able to re use my project as it is, since it was designed specifically for my remote. But I hope it can inspire some of you :)

What is inside?
============
- PLA
- one MG90 servo
- one external 5V USB power adapter
- four 5x1mm magnets
- one Adafruit ESP32 feather board and three wires

How does it work?
==============
Mechanical scheme
--------------------------
The servo is integrated in the body of the servoBox. It makes the centralGear briefly rotate 60 degrees left or right from the neutral 90° position and immediatly come back in pl