Dummy 13 Cat Tail

A cat tail for Dummy. Make it as long as you like—10 joints plus the adapter reaches the floor without the added tip on a regularly-configured Dummy. It's a tight enough fit to hold itself upright while also being posable. Pieces snap together easily (but also pop apart easily). I used the print settings recommended for frame parts on the Dummy 13 v1.0 page. Possible to print ant 100% (so scaled to 100%), but recommend to print at 150%. Must print in PETG. Alternate stand adapter and “lion-y” tail tip optional. Note: tail tip is a hard fit (minimal flex). A twenty-second soak in hot water does the trick for me—the thin part of the socket is prone to snapping at otherwise. Remix: Isolated the socket of the default “frame, clavicle” object and added a ball joint. Shrank the “frame, waist” object (that's what makes up the bulk of the tail). Reused that clavicle again to boolean together a “fluffy” tail tip. Most everything but the tail tip is a simple modification (rescaling, etc.