Thingiverse
Dungeon Pages storage bin
por lizmari
0
Descargas
0
Likes
0
Makes
Very simple open storage bin for Dungeon Pages print and play game. It should fit all currently published Dungeon Pages content if I have estimated correctly (as of Sep 14, 2025). I currently have the core set and Overland adventures with maps and characters laminated separately front and back. Interior measurements are approximately 180 x 66 x 140mm.
The cutout does not show up in the model images because did this in Cura.
I added the gcode file in case you want to use it. You will need to use 0% infill.
I can add the exact slicer settings later - I don't have time at the moment. Just make sure to use a 0.4 nozzle if you use the gcode file. The temp is set to 220 for the first 2 layers, and 210 after that. Speed is 30mm/s for the first 2 layers, and 180mm/s after that. It took 6.5 hrs to print on my Ender 3 V3 SE using these settings; Cura astimated 7hrs.
I used a 0.4mm nozzle, but you could probably print with 0.8mm to print faster. I also printed with enough layers so that the b
The cutout does not show up in the model images because did this in Cura.
I added the gcode file in case you want to use it. You will need to use 0% infill.
I can add the exact slicer settings later - I don't have time at the moment. Just make sure to use a 0.4 nozzle if you use the gcode file. The temp is set to 220 for the first 2 layers, and 210 after that. Speed is 30mm/s for the first 2 layers, and 180mm/s after that. It took 6.5 hrs to print on my Ender 3 V3 SE using these settings; Cura astimated 7hrs.
I used a 0.4mm nozzle, but you could probably print with 0.8mm to print faster. I also printed with enough layers so that the b
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!