Thingiverse

Duplicator 7 - Air Filtering System

by M600

162 Downloads

87 Likes

1 Makes

HODOOOOORRRRRR

Resin printer have great benefit but one of the major downside (beside being messy) is that the resin smell bad.

To solve that, here is a filtration unit that REPLACE the stock cover on your Duplicator 7 printer. The air is filtered using activated charcoal sheet. You might want to try pellets or any other thing you might think it would remove the odor.

Features:
- Easy swap out design.
- Dust tray.
- Self alignement of the fan using magnet.

Here is the guide:
- Print all the parts.
- Screw the dust tray on the bottom side of the base.
- Glue one magnet on each corner of the top base (CHECK POLARITY).
- Glue one magnet on each corner of the fan caddy (DOUBLE CHECK POLARITY).
- Screw the fan on his caddy.
- REMOVE the stock top plate from your cover.
- Screw the new cover in place.
Assembly done.

Charge your payload with odor removal material (activated charcoal), snap the fan on and that's it.

The unit can be used without any fan but won't be

duplicator duplicator 7 resin resin printer SLA Wanhao wanhao d7 Wanhao Duplicator 7 Wanhao Duplicator D7 duplicator duplicator 7 resin resin printer SLA Wanhao wanhao d7 Wanhao Duplicator 7 Wanhao Duplicator D7 duplicator duplicator 7 resin resin printer SLA Wanhao wanhao d7 Wanhao Duplicator 7 Wanhao Duplicator D7 duplicator duplicator 7 resin resin printer SLA Wanhao wanhao d7 Wanhao Duplicator 7 Wanhao Duplicator D7 duplicator duplicator 7 resin resin printer SLA Wanhao wanhao d7 Wanhao Duplicator 7 Wanhao Duplicator D7

Source

Thingiverse

What you need to print this: Advanced Low confidence

Why?

resin printing · significant post-processing

Single piece Hardware needed

Supports 1/3

Assembly 0/3

Settings 2/3

Bed size 0/3

Post-process 3/3

Printer