Duplo crane

-- have recently uploaded some "tight" files, if the holes on the crane base or hook are too sloppy on your printer you may want to print these instead--

Warning: some parts may break off and present a choking hazard to children, print and use at your own risk

OTHER BITS NEEDED:
Small self tapper screws x3
3M bolts x2 (or something similar)

MY PRINTER SETTINGS:
• 0.6mm nozzle
• Layer height: First layer 0.6mm, other layers 0.4mm
• Filament: PETG,
• Temp: 230 degrees hot end, 70 degrees plate
• Print parts in orientation shown, no supports, most prints will need some clean up. A few prints have an added brim to assist adhesion (I know these can be added in the slicing software but I tend to like brims in certain locations – ie corners, not just everywhere) some bits that slot together need a fair bit of “trimming” with a sharp knife, 0.3mm tolerances have been added in most places to help bits “slide” together, but the 0.6mm nozzle on my printer probably does not hel