Thingiverse
Duplo door
von Smats
8
Downloads
8
Likes
0
Makes
For a better result, I recommand to set the number of top and bottom layer to 999.
The part should fit without any XY correction. However, with Cura slicer, I recommand to set this setting to -.1mm.
The part should fit without any XY correction. However, with Cura slicer, I recommand to set this setting to -.1mm.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!