Thingiverse
Durafly Tundra Elevator Struts
von loosestkid_FPV
61
Downloads
33
Likes
1
Makes
The newer Tundra's are shipping with aftermarket struts for the elevators, and they are absolutely crap. So i've drawn some fittings that will hopefully do a better job of fixing it.
If you did not get the crap struts, they are 3x1mm profile and 110mm long.
To fix, use 1.8x10mm screws for the tail section, and notch the chamfer into the foam on the underside of the elevator, and hot glue, or use foam compatible glue.
You may also want to glue the carbon into the sockets.
This is my own design so tag me on insta, or give me some cred for using it.
I have also uploaded the 123design file, so you can tweak it if you can't source carbon of the same profile.
Hang sweet peeps.
If you did not get the crap struts, they are 3x1mm profile and 110mm long.
To fix, use 1.8x10mm screws for the tail section, and notch the chamfer into the foam on the underside of the elevator, and hot glue, or use foam compatible glue.
You may also want to glue the carbon into the sockets.
This is my own design so tag me on insta, or give me some cred for using it.
I have also uploaded the 123design file, so you can tweak it if you can't source carbon of the same profile.
Hang sweet peeps.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
