Thingiverse
Dust extraction adapter
by krikey
34
Downloads
23
Likes
1
Makes
I recently bought a Titan TTB674TAS Table Saw and also a Titan TTB430VAC Wet & Dry Vacuum. This adapter allows me to attach the supplied vaccum hose to the back of the table saw. It may fit other makes and models too.
You may want to print this using something a little stronger than PLA. Perhaps nylon.
The dimensions are as follows
Large outer diameter 56mm widening to 58mm so that it can have a nice push fit.
Smaller outer diameter 31mm.
Wall thickness is ~2mm. I may increase this to 3mm or 4mm so that PLA can be used.
If you liked my design and want to show your appreciation,why not leave a small donation of a £/$/€ or two through the blue TIP BUTTON on the left.
You may want to print this using something a little stronger than PLA. Perhaps nylon.
The dimensions are as follows
Large outer diameter 56mm widening to 58mm so that it can have a nice push fit.
Smaller outer diameter 31mm.
Wall thickness is ~2mm. I may increase this to 3mm or 4mm so that PLA can be used.
If you liked my design and want to show your appreciation,why not leave a small donation of a £/$/€ or two through the blue TIP BUTTON on the left.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
