Thingiverse
Dust Extractor Valve / Blast Gate (Customizable)
von MrFuzzy_F
1k
Downloads
652
Likes
0
Makes
In my woodworking workshop I am using HT DN50 tubes to connect the vacuum cleaner with the different tools like e.g the table saw.
In order to steer the airflow I designed this valve consisting of the valve housing and a slider.
Bottom and top side can be printed with either male or female connectors. The male one (=tube) can have be selected with outer or inner diameter of a DN50 tube. With outer diameter it would fit inside a standard DN50 female tube connector. With inner diameter it fits into the regular tube. The female connector accepts a regular DN50 tube.
I printed with support within the housing. The support can be stemmed out in slider direction. It might need a little force. The front of a flat file has just about the right size for this.
The slider should be a little smaIler than the slider opening. Set the delta according to the precision of the printer. If it still fits too tight: a little bit of filing helps.
The design is customizable, and might be scale
In order to steer the airflow I designed this valve consisting of the valve housing and a slider.
Bottom and top side can be printed with either male or female connectors. The male one (=tube) can have be selected with outer or inner diameter of a DN50 tube. With outer diameter it would fit inside a standard DN50 female tube connector. With inner diameter it fits into the regular tube. The female connector accepts a regular DN50 tube.
I printed with support within the housing. The support can be stemmed out in slider direction. It might need a little force. The front of a flat file has just about the right size for this.
The slider should be a little smaIler than the slider opening. Set the delta according to the precision of the printer. If it still fits too tight: a little bit of filing helps.
The design is customizable, and might be scale
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
