Dynam ME-262 Intakes

I wanted to try make some new scale intakes for the Dynam ME-262.
With my limited 3d skills, I only just managed to make these.
Feel free to modify the files to make them better, but then please share them again :-)

The intakes are printed in PLA at 0.2mm layer height, 0.7mm line width, 215c degrees for high strength, 50c bed temp., and at 25mm/s print speed. 0% infill. 1 perimiter shell, 2 top and 2 bottom layers.

In simplyfy 3D you need to go to the advanced page and select "Allow single extrusion walls" to print the thin walls...... Otherwise it just messes up.
I tried to load the STL' s into cura, and without any special settings, it will not work out..... But I have not looked into how to make it work.

Glue all the PLA parts together with medium/thick CA glue, and activator for maximum strength


EDIT.
I have uploaded my s3d FFF so you can look at it as a template if you need it.
Also, a problem has been reported with te rear intake part not being 100% flat cau