Dyson Airwrap Table Stand

This is a stand for a Dyson Airwrap that I made. It is meant to be placed on a table.All the models I found here had been a bit flimsy or did not suit my taste or required to be mounted to a wall.Or - what I found even worse - are made of two half-parts which then need to be glued together.This model can be printed with no supports on a single X1 / X1C plate with no supports.But there is a little catch - since I wanted the brushes and other parts to stay in place and due to being lazy, I used a part from DannyB3D.You can find the insert here: https://makerworld.com/en/models/225088-dyson-airwrap-accessory-modular-mount6 pcs are needed, they will easily fit onto one single print plate. Just one part - not the outer shell he made, but the internal part.Thanks Danny!You also need to use 6 screws with 3mm diameter (I used M3) to fix the snap-on holders. The 7th bolt has no hole in the lower part - just use a tapping screw or drill it.