Thingiverse
Dyson Stick Attachments Holder
von ESuser
0
Downloads
1
Likes
0
Makes
This is to wall mount my Dyson Stick Vacuum attachments in a closet. It uses two small screws to attach to the wall my you can set it on a surface too.
It fits two attachments that I commonly use.
You don't need supports to print this at all. Just a raft to prevent warping.
Printer Settings:
Zortax M200
Z-ABS
0.19mm layer height
20% infill
It fits two attachments that I commonly use.
You don't need supports to print this at all. Just a raft to prevent warping.
Printer Settings:
Zortax M200
Z-ABS
0.19mm layer height
20% infill
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!