Dyson V8 trigger lock v1.1

Dyson V8 trigger lock (v1.1) This is an updated version of my previous Dyson V8 trigger lock.What has changed: Before and after. What to print if you already have the previous version: If you have printed the previous version you will need to print the base and the trigger only. If so, just untick the check box next to the bolt assembly (see pic). Otherwise, you’ll need to print all the parts. Post processing:Base only.Remove the supports and use a needle type tool to remove them from the grooves. They just pop out. (Note: The picture above was published in the previous version – it shows only how to remove the supports from the grooves). What to sand: Sand (very little) wherever the support was touching, but do not sand the trigger rails (see below). Instructions (copied from the previous version): <p