E-cig Car Vent Holder

I made this holder so that I didn't have to hold my Itaste VV4 in my lap during long drives . I printed this in ABS so I could use an acetone glue to mate the two parts together. Since my e-cig is pretty tall I had to blue the clip higher up so that it didn't tip on hard braking. the square hole in the bottom is so you can charge it while driving. If you have a long enough USB cord you can use it in your car as well. The slot in the front is so I could see the display on my e-cig as well and it reduces print time.

I used 10% infil and I haven't had any issues with it yet.