Thingiverse
E-Flight Mini Motor Mount
von Shovelhead84
17
Downloads
11
Likes
0
Makes
This is an motor mount for brushless airplane motors. It was inspired by the wooden firewalls used on Flite Test mini airplane kits. It is intended to fit small brushless motors using 16mm bolt patterns (2204).
The screw holes are sized to allow for tapping.
Small holes at the top of the firewall allow for motor wire pass through.
The mounting plate should be large enough to accommodate most 12-20amp ESCs.
Firewall, 3mm
Mounting plate, 2mm
Sidewalls taper from 2mm - 1mm
The screw holes are sized to allow for tapping.
Small holes at the top of the firewall allow for motor wire pass through.
The mounting plate should be large enough to accommodate most 12-20amp ESCs.
Firewall, 3mm
Mounting plate, 2mm
Sidewalls taper from 2mm - 1mm
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!