Thingiverse
E-SCOOTER KIT
por sammywhiskas
37
Descargas
47
Likes
0
Makes
POST SOME MAKES PLEASE !
23/01/2020 Integrated horn with it's hub, it prints o.k. as one piece.
Completely made with Tinkercad !, I used a Wanhau i3 and an Anycubic Mega to print out the parts. Used mostly the standard settings with 25% infill but some with rafts and supports.
Found the wheels printed better in two halves, parts super-glued together. I left two square holes behind them for mating up purposes.(p.s. the rear wheel has the larger centre mocking the electric motor).
Some filing and trimming will be required as usual, including a little digging out for the rear seat hinge to fit.
A panel pin with the head cut off will suffice for the rear seat to hinge.
I was somewhat surprised that when the excess from the rear spring prints were removed that they actually work.
The foot-pegs revolve in the correct fashion, locking in the down and up positions. This is also the case for the side stand.
The steering turns to it's stops and the wheels rotate freely close to t
23/01/2020 Integrated horn with it's hub, it prints o.k. as one piece.
Completely made with Tinkercad !, I used a Wanhau i3 and an Anycubic Mega to print out the parts. Used mostly the standard settings with 25% infill but some with rafts and supports.
Found the wheels printed better in two halves, parts super-glued together. I left two square holes behind them for mating up purposes.(p.s. the rear wheel has the larger centre mocking the electric motor).
Some filing and trimming will be required as usual, including a little digging out for the rear seat hinge to fit.
A panel pin with the head cut off will suffice for the rear seat to hinge.
I was somewhat surprised that when the excess from the rear spring prints were removed that they actually work.
The foot-pegs revolve in the correct fashion, locking in the down and up positions. This is also the case for the side stand.
The steering turns to it's stops and the wheels rotate freely close to t
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!