Thingiverse
E Steps Helper
door Psyonic
3
Downloads
1
Likes
0
Makes
This is a very basic print to help fine tune the calibration of your E-Steps using 1.75mm filament.
It's job is to keep the filament straight while you measure it. For best results, a vernier calliper is recommended!
It's job is to keep the filament straight while you measure it. For best results, a vernier calliper is recommended!
Psyonic publiceert ook op
3 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
