Thingiverse
Robotics
Go to Model
E18-D80NK Sensor Mounts
11
Downloads
8
Likes
0
Makes
These are a few simple supports for the E18 IR sensor so you can mount it on any surface.
The diameter of the holes for the screws is 3.4mm so you can use an M3 screw or a 1/8" screw.
In one of the designs you can adjust the angle of the sensor by rotating it on its screw and holding the position with the other.
The diameter of the holes for the screws is 3.4mm so you can use an M3 screw or a 1/8" screw.
In one of the designs you can adjust the angle of the sensor by rotating it on its screw and holding the position with the other.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
