E3D Hemera Mount Kit for Duplicator i3 Plus

This mount for the Hemera requires a stand alone X-Axis Tensioner (Included) that is not connected to the mounting bracket. I have the Y-version of this available as well, just check my other Things. Both the X and Y Tensioners require a ball end hex wrench to adjust the tension. I've also designed adapters for the Diii and Ciii coolers (D/Ciii coolers designed by Pawpawpaw85). For the Diii there are two versions depending on how close you want the cooler from the Bed.

Please note that the Hemera bracket is designed to use M3 washers with the four M3x8mm screws that mount the stepper motor which should result in the screw coming just to the end of the nut. If you do not use the washer you must make sure that the screw will not bottom out in the stepper motor housing.

Enjoy!

Required Fasteners:

Mount to the X-Carrage:
- Six M4x8mm

Stepper Motor to Bracket:
- Four M3x8mm w/M3 washers

Limit Switch:
- Two M2x10mm
- Two M2 Nuts

X-Axis Tensioner:
- Belt Pins: Two M