Thingiverse
E3D v6 Lite brackets for Afinitbot A9
von DiscipleOfAckbar
5
Downloads
3
Likes
0
Makes
A bracket for a Afinibot A9 for mounting a E3D v6 lite hotend.
NOTE: I have not tested this bracket yet - so issues with this design may need some ironing out. I will revise this post/"Thing" when i know more.
It should not require support material for printing.
The bracket is made for use with
4x DIN/ISO 912 M2x30
4x DIN 934 M2 nut
there are hexagonal holes on the bottom, for a snug fit of the nuts.
NOTE: I have not tested this bracket yet - so issues with this design may need some ironing out. I will revise this post/"Thing" when i know more.
It should not require support material for printing.
The bracket is made for use with
4x DIN/ISO 912 M2x30
4x DIN 934 M2 nut
there are hexagonal holes on the bottom, for a snug fit of the nuts.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!