Thingiverse
E3D V6 Supercooling
by Br4ndosaurus
31
Downloads
28
Likes
1
Makes
Supercooling for your E3D V6! A 40mm heatsink fan and FOUR 40mm print cooling fans! Very aerodynamic and sleek, this flows exceedingly well. This snaps on to the heatsink quite tight! Made for my gearbest E3D V6 clone, but should also fit originals! The V6 heatsink shaft diameter is 22.27mm and the V6 heatsink height is 26.15mm. A bit of refining went into the inside to optimize flow and onto the outside to match aesthetically. Everything is supposed to be tight and solid once it's in its desired location. I would recommend printing the mount and the arms solid. This works like a dream for the heatsink and on full power the print cooling fans put out so much air it they down the heatblock! I only run mine at full power for bridging.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
